| HH-300 12" Adjustable Hole Cutter
Twin Blade Replaceable
|
|
|
|
- Intended for use only in Stationary Drill Press
|
- Replaceable cutter blades and pilot drill. Economical, replace the blades or drill, not the complete hole cutter.
|
- Precision sharpened cutter blades for smooth, accurate cuts.
|
- To extend the cutting depth to 2” (50 mm), stop boring when the pilot drill extends through the work piece. Then, using the drill bit as a guide, start cutting the hole from the opposite side.
|
- Easily adjusts to cut the exact size hole needed
|
- Scale shows diameter of hole – for 3” hole set each blade holder at the 3" mark on the bar.
|
- Measurements are shown in inches and millimeters.
|
|
|
|
|
Specification |
|
Cutting Diameter
|
1 9/16" (40 mm) - 12" (300 mm)
|
|
Cutting Thickness
|
1/8" - 1" (25mm) -- 2" when can be cut from both sides.
|
|
Drill Shank
|
3/8" (10 mm)
|
|
Blade Material
|
High speed steel
|
|
Cutting Materials
|
Plywood, veneer, woodboard. plasterboard, acrylic sheet. Thin asbestos slate, etc.
|
|
|
|
